A walkthrough on how i build my interactable spas.
First: build your deck. I used the metal floor to make things easier to see. Second: snap four short walls with one level above and three levels down. Third: snap a metal floor at one and two levels below your deck level. (Again using the metal floor will help to line up the furnature.) Fourth: place upholstered chairs like in the image. It helps to use the build camera from directly above. Fifth: delete the floor the chairs are sitting on while leaving the floor below it. Sixth: line up a light table in the perfect center of the floor and, without moving it, scale it as large as it will go and place. Again viewing this from directly above makes this way easier. Last: snap a timber sail roof on the short walls so it lays flush with your deck, then delete the top short wall. And enjoy your new spa! NOTE: the chairs can be swapped out for the corner couches as seen above. And for an uncovered look use the wooden glass floors to make a clean deck surround. submitted by /u/Bakasan076 |